Gear units C D 8 A B 1-100 A3 SHEET 1 OF 1 REVISION BOTH ENDS OF EACH RACK ARE MACHINED TO ALLOW FOR CONTINUOUS MOUNTING WE RECOMMEND THE USE OF A MOUNTING PIECE AND GREASE OR OIL LUBRICATION Worms and Worm Wheels worm 7 .0 FAX: 01827 253390 www.apex-trans.co.uk TEL: 01827 253340 sales@apex-trans.co.uk 35 * Stainless Steel (1.4305) = h9, ETG®100 = h6 ground bar diameter ** ETG®100 high quality alloy steel has 960-1100 N/mm² tensile strength MOD Length (mm) Tooth Number Ø D * h9 / h6* H HA (PCD) B Mass (kg) Order Code X8 CrNis 18-9 ETG®100 ** 1 499.51 159 10 10 9 6 0.7 141-510-050 141-410-050 999.02 318 1.4 141-510-100 141-410-100 1.5 499.51 106 15 15 13.5 9 0.9 141-515-050 141-415-050 999.02 212 1.8 141-515-100 141-415-100 2 502.65 80 20 20 18 12 1.1 141-520-050 141-420-050 999.02 159 2.2 141-520-100 141-420-100 3 499.51 53 30 30 27 18 2.5 141-530-050 141-430-050 999.02 106 5.1 141-530-100 141-430-100 1998.05 212 10.2 - 141-430-200 4 502.65 40 40 40 36 24 4.5 - 141-440-050 1005.30 80 9.1 - 141-440-100 2010.62 160 18.2 - 141-440-200 Helix Angle Pressure Angle Tooth Quality Tooth Finish Material Hardness STRAIGHT 0° 20° Q8 h27 Milled Stainless / ETG®100 Soft L B D HA H 1 2 3 4 3 2 1 5 4 6 7 141-631 WEIGHT: S SCALE:1:5 DWG NO. TITLE: DO NOT SCALE DRAWING MATERIAL: DATE SIGNATURE NAME DEBUR AND BREAK SHARP EDGES FINISH: UNLESS OTHERWISE SPECIFIED: DIMENSIONS ARE IN MILLIMETERS SURFACE FINISH: TOLERANCES: LINEAR: ANGULAR: Q.A MFG APPV'D CHK'D DRAWN Straight Round Racks Stainless Steel & ETG®100 Alloy Steel